Dealer Request a Quote

Dealer Information

Company Name

First Name

Last Name

Phone/Mobile

Country

State/Territory

Province/Territory

State/Province/Territory

Zip

Well Information

Tracking Code (Your Customer's Name)

Please remove any special characters !"#¤%&/()=?`^*>;:@£${[]}|~\,.'¨´+- from the Tracking Code field.

Where is your well?

What is the depth of the well (in feet)

This is measured from the ground level down. This is the distance from the ground level to the solid bottom of the well. This measurement is a larger number (further down) than the static water level measurement and the current pump set position (if any).

What is the static water level (in feet)

The static water level is measured from the ground level down. This is the stable water level in your well when you have not recently been pumping water.

The static water level measurement is:

Estimated

Measured

What is the Recovery Rate of the well?

What is the Freezing level / frost line? (in inches)

This is to ensure that your pump will not freeze. If you do not know, please contact your local utilities/authorities, well company, or builder.

What is the inside diameter of the casing?

Casing Inside Diameter Other

What is the casing rise above ground level?

Pump Configuration

Is there a pump in the well now?

What size is the submersible pipe?

1 (~1.3" outer diameter), 1.25 (~1.65" outer diameter), 1.5 (~1.9" outer diameter), 2.0 (~2.4" outer diameter), Other (provide details below)

There are a couple types of pitless adapters that will not allow a hand pump to be installed. You will need to remove the cap in order to verify. One will not allow the well cap to be installed correctly and the other does not provide the necessary clearance. If you have either of the two types of pitless adapters shown, you will need to change to a different type of pitless adapter in order to install a hand pump. Make sure to verify this before ordering, once the system is shipped standard return policy applies.

Please add details about a pump in the well.

What is the Position/set of the current pump (in feet)?

This is measured from the ground level down. This is where the current pump is set. This measurement is a larger number (further down) than the static water level measurement.

Are you going to pump to a pressure tank? (now or future)

Most people pump into their home's pressure tank to have water available to the taps and fixtures.

YES

DEFINITELY NEVER

Is there any vertical rise from the well head up to the point of delivery?

When you are standing at the well head (ground level), is the water going somewhere roughly to the same level? If the water is going up a slope, what is the vertical height of the destination above the well head? (in feet)

Are you interested in adding a motor? (now or future)

Simple Pump's low-power-draw motors operate to a maximum of 225' static water level. Suitable for solar or other 12v or 24v DC source.

Yes

What is your motor interest?

Do you have any questions or additional information you think would be useful?

File Upload

If you think it will be useful, please attach the well report or a picture of the well.

Choose File